Worm Gear
Legende | ||
i = gear ratio | da1 = tip diameter (worm) | T2 = output torque |
γm = Lead angle | z2 = No. of teeth | MF = mineral grease |
mn = module | dm2 = pitch diameter (worm gear) | MÖ = mineral oil / synthetic grease |
z1 = number of threads | dA = max. diameter (worm gear) | SÖ = synthetic oil |
dm1 = pitch diameter (worm) | – | – |
All worms and worm gears are available for the right hand only.
Worms are case-hardened and ground steel (HV 620 – 700).
The worm gear is made of CuZn37Mn3Al2PbSi-S40 or CuZn37Mn3Al2Si°. Made of plastic or HGW 2083 upon request.
What are worm gears and where are they used?
A worm gear consists of a worm and also a gear (in some cases called a worm gear) with non-parallel, non-intersecting shafts at 90-degree angles to each other. The worm is similar to a screw having a V-thread, and the gear is similar to a spur gear. The worm is usually the drive part; the threads with the worm propel the teeth with the gear.Like a ball screw, the worm in a worm gear may have a single or multiple ends – which means there are multiple threads or helixes on the worm. With a single-ended worm, the gear advances one tooth for every full revolution (360 degrees) of the worm. Therefore, a gear with 24 teeth will provide a gear reduction ratio of 24:1. For multi-start worms, gear reduction is equal to the number of teeth on the gear divided by the number of starts on the worm. (This is unlike most other types of gears, where gear reduction is a function of the diameter of the two components.)